Need more water.

GetHuman-jdbeac's tech support issue with Whirlpool from May 2019

Help with my Whirlpool issue
The issue in GetHuman-jdbeac's own words
Clean clothes with sufficient water ... We have a serious low water level problem with our Maytag washer MVWB*** FW serial*C********. Loads often are above the water level and not even wet. Can the water level be increased? None of the settings seem to increase the water level. What can Whirlpool suggest I do to correct this problem?
You can’t add more water than is programmed into the machine
Replace the machine with one that adds enough water or fix this one.
Since **** never had a problem with my other Maytag washer just this new one purchased ****.
Called for service. Service man did not have an answer for this problem .
I have an issue with Whirlpool too
How GetHuman-jdbeac fixed the problem
I didn’t get it fixed and I did not get any help from anyone, we are looking at throwing these Maytag units out and purchasing a reliable brand.
Please help with my Whirlpool issue
Do you have a customer issue as well?
We can help you get Whirlpool's attention and get better help faster. Tap below to get started.
Having Whirlpool issues too?
Get tips from pros & other customers, and get it handled faster:
For better results, write at least 100 characters
This email address isn't valid

Whirlpool

Maytag Washer top load.
tech support issue
Reported by GetHuman-jdbeac
May 20th, 2019 - a mon ago
I have an issue with Whirlpool too
Fixed
GetHuman-jdbeac shared how to fix
Seen by 13 customers so far
Similar issue to 1556 others
0 customers following this
Items needed
Name
Email address
Billing address
Phone number
Order number
Timeline
GetHuman-jdbeac started working on this issue
May 20th 7:56pm
GetHuman-jdbeac indicated the issue is not fixed yet.
May 21st 11:12pm
GetHuman-jdbeac indicated the issue is not fixed yet.
May 22nd 11:02am
GetHuman-jdbeac indicated the issue is not fixed yet.
May 23rd 9:31pm
GetHuman-jdbeac indicated the issue is not fixed yet.
May 23rd 9:34pm
GetHuman-jdbeac confirmed the issue is fixed. Hooray!
May 23rd 9:34pm